Techniques to Shut Off Your Homes Water Supply
Techniques to Shut Off Your Homes Water Supply
Blog Article
Every person has his or her own rationale about How to Locate & Turn Off Main Water Shut-Off Valves.
If you attempt to shut the water off to your components by using an angle quit and that does not work you will certainly have to close of the water main to make your repair service. There are also lots of various other reasons you could need to close the water main like repairing icy pipes, fixing leakages, replacing components or faucets.
Lots of people are not aware that they even have a water pipe valve right in their very own house and also just call a plumber of never end up doing the repair up until points get truly bad since they merely do not know that shutting the water main is actually easy.
The most usual places a water main will certainly be located in home remains in your boiler room, cellar, or a cut out panel in a section for your residence.
Once you find the water pipe you will merely turn the shutoff clockwise to shut all the water off in your house till you have completed the repair service. Some residences will have a ball shutoff with a bar that you can pull instead of look to close the water off.
How to Find Your Home Water Main
Weather is becoming more extreme every year. That means higher risks of flash floods and storm surges, even in places normally not used to it. Today, we’ll give you some guidance on how to find your home’s water main (shutoff valve). Knowing where your water shutoff valve is can prevent catastrophic flood damage, longer-term plumbing damage, and help you stop plumbing leaks. It’s also something that’s just good to know.
Where is your home water main (shutoff valve)?
Inside your house, likely on a wall on the street side of your house In warmer climates, outside your home near an outside faucet Outside your house, near your curb, under a plastic or metal lid likely marked water Outside your house, near your private well pump and/or near your pressure tank The first three options apply if you use municipal water (i.e., city water). The fourth option applies if you use well water. So, the first step in finding your main water shutoff valve is figuring out whether your water supply is municipal or well. In general (but not always), if you pay a water bill, chances are you use municipal water.
Now, let’s look at some specific tips for finding each kind of water shutoff valve. The best time to do this is before you need to. So, take a few minutes on a nice day to look for your shutoff valve, instead of waiting until you need to know where it is.
Where to look INSIDE your house for the shutoff valve
First, start by going outside to the front of your house. Look for a faucet that comes out from the wall on the outside. This will help you narrow down where your indoor water shutoff valve might be.
Next, go back inside and to the lowest part of your house (basement or first floor). Recall where the outdoor faucet was. Walk to the location on your inside wall, about where the outside faucet appears on the outside. If you see either a lever or a wheel valve connected to metal pipes, you’ve likely found your water shutoff valve. (If not, go to the next section.)
Then, turn the valve clockwise (to the right) until it stops. If it’s a lever-style valve (i.e., ball valve), you’ll turn it a quarter turn so that the valve is perpendicular (i.e., like a cross) to the pipe it’s connected to. If it’s a wheel-style valve (i.e., gate valve), turn the wheel clockwise until it stops.
Near an outside faucet
If you live in a warmer climate, check the faucets connected to your house. You’ll likely see that one of your faucets has either a lever or wheel valve right next to it. That’s your shutoff valve.
Turn the valve clockwise (to the right) until it stops. It it’s a lever-style valve (i.e., ball valve), you’ll turn it a quarter turn so that the valve is perpendicular (i.e., like a cross) to the pipe it’s connected to. If it’s a wheel-style valve (i.e., gate valve), turn the wheel clockwise until it stops.
In the ground near your curb
If you didn’t find your main water supply inside or connected to your house, check your street-side curb. Your shutoff valve may be housed in a cement box with a plastic or metal lid that says water. You’ll need a water meter key, which you can buy at a hardware store, or sturdy pliers for this.
First, you’ll first want to remove the lid. If the lid is locked, you’ll need to call your municipal water service for instructions on how to open it.
If there’s dirt or sand inside, remove it and put it to the side. You’ll need to put it back when you’re through, as the dirt or sand prevents freezing.
Next, you’ll likely see two valves. Only use the valve that is closest to your house. The other valve is the city valve, which you don’t want to fiddle with. (You likely won’t be able to, since it requires special tools, but just steer clear of it entirely.)
Using the water meter key or your pliers, turn the valve clockwise to close it. Reverse the process to turn it back on. But remember: When turning the water back on, GO SLOW with your counterclockwise turn.
https://www.2-10.com/blog/how-to-find-home-water-main-shutoff-valve/
Do you really like reading up on How to Turn Off the Water in an Emergency? Post feedback further down. We will be interested to hear your ideas about this write-up. Hoping that you visit us again in the near future. If you enjoyed reading our blog post plz be sure to share it. Bless you for your time. Visit us again soon.
Click Here To Find Out More Report this page